User Manual
Table Of Contents
- Legal Information
- Available Model
- Regulatory Information
- Safety Instruction
- 1 Overview
- 2 Appearance
- 3 Activation
- 4 Enroll Administrator's Face
- 5 Enroll via Device
- 6 Enroll via Client Software
- 7 Basic Operation
- A. Tips When Collecting/Comparing Face Picture
- B. Tips for Scanning Fingerprint
- C. Communication Matrix and Device Command
equipment installaon on vibraons surface or places subject
to shock (ignorance can cause equipment damage).
•
Do not place the device in extremely hot (refer to the
specicaon of the device for the detailed operang
temperature), cold, dusty or damp locaons, and do not
expose it to high
electromagnec radiaon.
•
The device cover for indoor use shall be kept from rain and
moisture.
•
Exposing the equipment to direct sun light, low venlaon or
heat source such as heater or radiator is forbidden (ignorance
can cause
re danger).
•
Do not aim the device at the sun or extra bright places. A
blooming or smear may occur otherwise (which is not a
malfuncon however), and aecng the endurance of sensor
at the same
me.
•
Please use the provided glove when open up the device cover,
avoid direct contact with the device cover, because the acidic
sweat of the ngers may erode the surface coang of the
device cover.
•
Please use a so and dry cloth when clean inside and outside
surfaces of the device cover, do not use alkaline detergents.
•
Please keep all wrappers aer unpack them for future use. In
case of any failure occurred, you need to return the device to
the factory with the original wrapper.
Transportaon without
the original wrapper may result in damage on the device and
lead to
addional costs.
•
Improper use or replacement of the
baery may result in
hazard of explosion. Replace with the same or equivalent type
only. Dispose of used baeries according to the instrucons
provided by the baery manufacturer.
•
Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
level, use mulple authencaon modes.
•
Input voltage should meet both the SELV (Safety Extra Low
Voltage) and the Limited Power Source with 100~240 VAC or
12 VDC according to the IEC60950-1 standard. Please refer to
technical
specicaons for detailed informaon.
•
Please take care of your card and report card loss in me when
card is lost.
•
Mulple card types are supported. Please select an appropriate
card type according to the card performance and the usage
scenarios.
•
Working temperature: -10 °C to 50 °C (14 °F to 122 °F)
vii