Quick Start Guide

Access Control Terminal·Quick Start Guide
19
6 Activating Access Control Terminal
Purpose:
You are required to activate the terminal first before using it.
Activation via SADP, and Activation via client software are supported.
The default values of the control terminal are as follows.
 The default IP address: 192.0.0.64.
 The default port No.: 8000.
 The default user name: admin.
Activating via Device 6.1
If the device is not activated, you can activate the device after it is powering on.
Figure 6-1 Device Activation Interface
Steps:
1. Use the Up, Down, Left, Right key to move the cursor to the Password textbox and create the
password for device activating.
1) Tap the key (Edit key) to enter the editing mode.
Figure 6-2 Input Text
2) Tap F1 key to switch the input method.
3) Enter the card number into the textbox.
4) Tap the key to exit the editing mode.
2. Move the cursor to the Confirm Password textbox and input the password again.
3. Move the cursor to # Activate and tap the # key to active the device.