Quick Start Guide
Table Of Contents
- 1 Overview
- 2 Appearance
- 3 Installation
- 4 Terminal Connection
- 5 Wiring Description
- 6 Activating Access Control Terminal
- 7 Basic Operation
- Appendix: Tips for Scanning Fingerprint
Access Control TerminalยทQuick Start Guide
33
Figure 7-17 Wi-Fi Selection
4. Move the cursor to a network, and tap # key to enter the network connection interface.
Figure 7-18 Wi-Fi Settings
5. Input the password of the network. The password supports numbers, letters (uppercase and
lowercase) and symbols.
6. Edit the IP mode, IP address, subnet mask, and gateway address.
7. Move the cursor to the OK button, and tap the # key.
Tap the key to enter and exit the editing mode.
System Settings 7.4
Purpose:
On the system settings interface, you can set system parameters, manage the data, restore default
settings, set access control parameters, and set cameras.
Steps:
1. Move the cursor to System (system parameters) by using direction keys.
2. Tap the # key to enter the system parameters interface.