Quick Start Guide

Access Control Terminal·Quick Start Guide
36
Figure 7-21 Data Management Interface
Move the cursor to Delete Card Parameters, Delete Event Only, or Delete Picture Only.
Delete Card Parameters: Delete all cards parameters registered in the device.
Delete Event Only: Delete all access events in the system.
Delete Picture Only: Delete all captured pictures in the system.
This function is only supported by terminal with the model of –C.
3. Tap the # key.
7.4.3 Restoring Settings
Purpose:
On the restore settings interface, you can restore Factory Defaults or Default Settings.
Steps:
1. Move the cursor to Reset (restore settings) by using direction keys on the system settings
interface.
2. Tap the # key to enter the restore settings interface.
Figure 7-22 Restore Settings Interface
3. Move the cursor to Factory Defaults or Default Settings.
Factory Defaults: After restoring factory defaults, all parameters of the device are returned to
the factory defaults.
Default Settings: After restoring defaults settings, parameters, excluding network parameters
and event parameters, are returned to the factory defaults.
4. Tap the # key.