Quick Start Guide

Access Control Terminal·Quick Start Guide
37
5. Move the cursor to the OK button, and tap the # key.
7.4.4 Door Settings
Purpose:
On the door settings interface, you can set door parameters, including Controller Authentication,
Card Reader Authentication, Door Action Time, Delayed Door Alarm, and Anti-passing Back.
Steps:
1. Move the cursor to ACS (door settings) by using direction keys in the system settings interface.
2. Tap the # key to enter the door settings interface.
Figure 7-23 Door Settings Interface
3. Edit door parameters.
Controller Authentication:
Set the controller authentication mode for opening the door,
that is, Card Only, Fingerprint Only, Card/Fingerprint, Card &
Fingerprint, Card & Password, Fingerprint & Password, Card &
Fingerprint & Password.
Card Reader Authentication:
Set the card reader authentication mode for opening the door,
that is, Card Only, Fingerprint Only, Card/Fingerprint, Card &
Fingerprint, Card & Password, Password & Fingerprint, Card &
Password & Fingerprint.
Door Action Time:
Set the door action time: 1 ~ 255 s.
Delayed Door Alarm:
Set the delayed door alarm threshold: 1 ~ 255 s.
Anti-Passing Back:
Set whether to enable the function of anti-passing back.
 Tap the key to enter and exit the editing mode.
 Tap the Right/Left direction keys to choose contents.
 Tap the # key to switch the mode between “Yes” mode and “No” mode.
4. Move the cursor to the OK button, and tap the # key.
7.4.5 Setting Camera
Purpose:
On the camera settings interface, you can set camera parameters.
This function is only supported by terminal with the model of –C.
Steps: