User Manual

Access Control Terminal·User Manual
98
2. You can editing the following parameters:
 Door Magnetic: The Door Magnetic is in the status of Remain Closed (excluding special
conditions).
 Exit Button Type: The Exit Button Type is in the status of Remain Open (excluding special
conditions).
 Door Locked Time: After swiping the normal card and relay action, the timer for locking
the door starts working.
 Door Open Duration by Card for Disabled Person: The door magnetic can be enabled with
appropriate delay after disabled person swipes the card.
 Door Open Timeout Alarm: The alarm can be triggered if the door has not been close
 Enable Locking Door when Door Closed: The door can be locked once it is closed even if
the Door Locked Time is not reached.
 Duress Code: The door can open by inputting the duress code when there is duress. At the
same time, the client can report the duress event.
 Super Password: The specific person can open the door by inputting the super password.
 Dismiss Code: Input the dismiss code to stop the buzzer of the card reader.
Notes:
 The duress code, Super password, and dismiss code should be different.
 The duress code, super password, and the dismiss code should be different from the
authentication password.
 The duress code, super password, and the dismiss code should contain 4 to 8 numerics.
3. Click Save button to save parameters.
Card Reader Parameters
Steps:
1. In the device list on the left, click to expand the door, select the card reader name and you
can edit the card reader parameters on the right.