User Manual

Access Control Terminal·User Manual
111
 The target door and the source door cannot be the same one.
3. Click Save button to save and take effect of the parameters.
Card Linkage
Steps:
1. Click to select the linkage type as Card Linkage.
2. Input the card No. or select the card from the dropdown list.
3. Select the card reader from the table for triggering.
4. Set the linkage target, and switch the property from to to enable this function.
 Host Buzzer: The audible warning of controller will be enabled/disabled.
 Capture: The real-time capture will be enabled.
 Card Reader Buzzer: The audible warning of card reader will be enabled/disabled.
 Alarm Output: The alarm output will be enabled/disabled for notification.
 Access Control Point: The door status of open, close, remain open, and remain closed will
be enabled.
5. Click Save button to save and take effect of the parameters.
8.11.3 Cross-Device Linkage
Purpose:
You can assign to trigger other access control device’s action by setting up a rule when the access
control event is triggered.
Click Cross-Device Linkage tab to enter the following interface.
Click Add button to add a new client linkage. You can select the event source as Event Linkage or
Card Linkage.