User Manual

Access Control Terminal·User Manual
76
6. (Optional) Select the NIC Type.
7. (Optional) Select to uncheck Enable DHCP and set the IP address, the subnet mask, the default
gateway, the MAC address, the DNS1 IP Address, and the DNS2 IP address.
8. Click Save to save the settings.
Configuring Relay Parameters
Steps:
1. Click Alarm -> Relay.
You can view the relay parameters.
2. Click the to pop up the Relay Parameters Settings window.
3. Set the relay name and the output delay.
4. Click Save to save the paramters.
Or click Copy to… to copy the relay information to other relays.
Configuring Access Control Parameters
Steps:
1. In the Remote Configuration interface, click Other -> Access Control Parameters.
2. Select and check the item as you desired.
 Display Detected Face Pictures: Display face picture when auththenticating.
 Display Card No.: Display the card infomratio when authenticating.
 Display User Information: Display the user infomration when authenticating.
 Overlay User Information on Picture: Display the user infomration on the captured picture.
 Enable Voice Prompt: If check the checkbox, the voicce pormpt is enabled in the device.
You can hear the voice prompt when operating in the device.
 Upload Pictures after Capturing: If check the checkbox, the pictures captured by linked
camera will be upload to the system automatically.
 Save Captured Pictures: If you check the checkbox, you can save the picture capured by
linked camera to the device. You can view the picture in 8.10 Searching Access Control
Event.
 Press Key to Input Card No.: If you check the checkbox, you can input the card No. by
pressing the key..
3. Click Save to save the settings.