User Manual

If enabled, the captured face picture when authencang will be saved on the device.
ECO Mode
Aer enabling the ECO mode, the device can authencate faces in the low light or dark
environment. And you can set he ECO mode threshold, ECO mode (1:N), and ECO mode (1:1).
ECO Mode (1:1)
Set the matching threshold when authencang via ECO mode 1:1 matching mode. The
larger the value, the smaller the false accept rate and the larger the false rejecon rate.
ECO Mode (1:N)
Set the matching threshold when
authencang via ECO mode 1:N matching mode. The
larger the value, the smaller the false accept rate and the larger the false rejecon rate.
ECO Mode Threshold
When enabling the ECO mode, you can set the ECO mode's threshold. The larger the value,
the easier the device entering the ECO mode. Available range: 0 to 8.
Face with Mask & Face 1:N (ECO)
Set the matching threshold when
authencang via face with mask & face in ECO mode 1:N
matching mode. The larger the value, the smaller the false accept rate and the larger the
false
rejecon rate.
Work Mode
Set the device work mode as Access Control Mode. The access control mode is the device
normal mode. You should authencate your credenal for accessing.
5. Click Save.
Enable M1 Card
Encrypon
M1 card encrypon can improve the security level of authencaon.
Steps
Note
The funcon should be supported by the access control device and the card reader.
1. Enter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click M1 Card
Encrypon Vericaon to
enter the M1 Card Encrypon Vericaon page.
4. Set the switch to on to enable the M1 card
encrypon funcon.
5. Set the sector ID.
Face Recognion Terminal User Manual
143