User Manual

Table Of Contents

Steps

Note

The funcon should be supported by the device.

Tap Comm.

(Communicaon Sengs) on the Home page to enter the Communicaon Sengs

page.

2. On the

Communicaon Sengs page, tap.

Figure 7-5 Wi-Fi Sengs

3. Enable the Wi-Fi funcon.

4. Congure the Wi-Fi parameters.

Select a Wi-Fi from the list, and enter the Wi-Fi's password. Tap OK.

If the target Wi-Fi is not in the list,tap Add Wi-Fi. Enter the Wi-Fi's name and password. And

tap OK.

Note

Only digits, leers, and special characters are allowed in the password.

5. Set the Wi-Fi's parameters.

By default, DHCP is enable. The system will allocate the IP address, the subnet mask, and the

gateway automacally.

Face Recognion Terminal User Manual