User Manual

Note
The funcon should be supported by the device.
Steps
1. Click
Conguraon → Network → Advanced → HTTP Listening .
2. Edit the
desnaon IP or host name, URL and port.
3.
Oponal: Click Test to test whether the entered IP address or host name are valid.
4. Oponal: Click Default to reset the desnaon IP or host name.
5.
Click Save.
8.5.13 Set Video and Audio Parameters
Set the image quality, resoluon, and the device volume.
Set Video Parameters
Click Conguraon → Video/Audio → Video .
Figure 8-8 Video Sengs Page
Set the stream type, the video type, the bitrate type, the frame rate, the Max. bitrate, and the
video encoding.
Click Save to save the
sengs aer the conguraon.
Set Audio Parameters
Click Conguraon → Video/Audio → Audio .
Set the audio stream type and audio encoding.
You can also drag the block to adjust the device input and output volume.
Click Save to save the
sengs aer the conguraon.
Note
The funcons vary according to dierent models. Refers to the actual device for details.
Face Recognion Terminal User Manual
74