User Manual

Note
This funcon should be supported by the device.
7. Set the related
aendance me parameters as the following:
Start/End-Work Time
Set the start-work
me and end-work-me.
Valid Check-in/out Time
On the me bar, adjust the yellow bar to set the metable during which the check-in or
check-out is valid.
Calculated as
Set the duraon calculated as the actual work duraon.
Late/Early Leave Allowable
Set the metable for late or early leave.
8. Set absence related parameters.
Check-In, Late for
You can set the late
me duraon for the employee who has checked in but is late for work.
If the employee exceeds the required me period, his/her aendance data will be marked as
absent.
Check-Out, Early Leave for
You can set the early leave
me duraon for the employee who checks out earlier than the
normal leave me, and his/her aendance data will be marked as absent.
No Check-in
If the employee does not check in, his/her aendance data may be marked as absent or late.
No Check-Out
If the employee does not check out, his/her aendance data may be marked as absent or
early leave.
9. Click Save to add the
metable.
10. Oponal: Perform one or more following operaons aer adding metable.
Edit Timetable
Select a metable from the list to edit related informaon.
Delete Timetable Select a metable from the list and click Delete to delete it.
9.11.3 Add Shi
You can add shi for employees including seng shi period (day, week, month) and the eecve
aendance me. According to the actual requirements, you can adding mulple metables in one
shi for employees, which requires them to check in and check out for each metable.
DS-K1T680 Series Face Recognion Terminal User Manual
149