Configuration Manual

1.7.1 Local Network Conguraon
Steps
1.
Click Local Network Conguraon to enter local network conguraon page.
Figure 1-24 Local Network Conguraon
2.
Enter the Local IP Address, Subnet Mask, Default Gateway, Port and HTTP Port.
3.
Click Save to enable the sengs.
Note
•
The default port No. is 8000.
•
Aer eding the local network parameters of device, you should add the
devices to the device list again.
1.7.2 Linked Device Network Conguraon
Before You Start
On the linked devices network
conguraon page, you can congure the network
parameters of master staons, SIP servers and management centers of the same
LAN. The devices can be linked to the door staon and realize the linkage between
these devices.
Steps
1.
Click Linked Network Conguraon to enter linked network conguraon page.
Module Door
Staon Conguraon Guide
18