Configuration Manual

Conguraon sengs is required before starng using the indoor staon. It is
necessary to set the indoor staon network, room No., linked devices, device me
display, and so on.
1.2.1 Set Indoor Staon Network Parameters
Network connecon is mandatory for the use of the indoor staon. Set the network
parameters
aer acvang the indoor staon. Only when the IP address of the
indoor staon is in the same network segment as other devices, it can work properly
in the same system.
Steps
Note
The default IP address of the indoor staon is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1.
Tap
Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap
to enter the network sengs page.
Figure 1-2 Network Sengs
3.
Set the network parameters.
-
Enable DHCP, and the system can assign an IP address of the indoor staon
automacally.
-
Disable the DHCP funcon, and set the IP address manually. You should set
the device IP address, the gateway, the DNS address.
1.2.2 Set Linked Device IP
Network Indoor Staon Conguraon Guide
2