Quick Start Guide

Body Camera Quick Start Guide
4
Safety Instruction
Laws and Regulations
Use of the product must be in strict compliance with the local laws and regulations. Please shut down the device
in prohibited area.
Power Supply
 Use of the product must be in strict compliance with the local electrical safety regulations.
 Use the power adapter provided by qualified manufacturer. Refer to the product specification for detailed
power requirements.
 It is recommended to provide independent power adapter for each device as adapter overload may cause
over-heating or a fire hazard.
 Make sure that the power has been disconnected before you wire, install, or disassemble the device.
 DO NOT directly touch exposed contacts and components once the device is powered up to avoid electric
shock.
 DO NOT use damaged power supply devices (e.g., cable, power adapter, etc.) to avoid electric shock, fire
hazard, and explosion.
 DO NOT directly cut the power supply to shut down the device. Please shut down the device normally and
then unplug the power cord to avoid data loss.
 DO NOT block the power supply equipment to plug and unplug conveniently.
 Make sure the power supply has been disconnected if the power adapter is idle.
 Make sure the device is connected to the ground firmly.
Transportation, Use, and Storage
 To avoid heat accumulation, good ventilation is required for a proper operating environment.
 Store the device in dry, well-ventilated, corrosive-gas-free, no direct sunlight, and no heating source
environment.
 Avoid fire, water, and explosive environment when using the device.
 Avoid lightning strike for device installation. Install a lightning arrester if necessary.
 Keep the device away from magnetic interference.
 Avoid device installation on vibratory surface or places, and avoid equipment installation on vibratory
surface or places subject to shock (ignorance may cause device damage).
 DO NOT touch the heat dissipation component to avoid burns.
 DO NOT expose the device to extremely hot, cold, or humidity environments. For temperature and humidity
requirements, see device specification.
 The device can only be safely used in the region below 2000 meters above the sea level.
Maintenance
 If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable,
and contact the service center.
 If the device is abnormal, contact the store you purchased it or the nearest service center. DO NOT
disassemble or modify the device in any way (For the problems caused by unauthorized modification or
maintenance, the company shall not take any responsibility).
 Keep all wrappers after unpacking them for future use. In case of any failure occurred, you need to return
the device to the factory with the original wrapper. Transportation without the original wrapper may result
in damage to the device and the company shall not take any responsibility.
Network
 Please enforce the protection for the personal information and the data security as the device may be
confronted with the network security problems when it is connected to the Internet. Please contact us
when the device might exist network security risks.
 Please understand that you have the responsibility to configure all the passwords and other security settings
about the device, and keep your user name and password.