User Manual
Table Of Contents
- Chapter1 Introduction
- Chapter 2 Startup and Shutdown
- Chapter 3 Basic Functions
- Chapter 4 Network Configuration
- Chapter 5 Camera Configuration
- Chapter 6 System Configuration
- 6.1 Set System Sound
- 6.2 Set Voice Prompt
- 6.3 Turn on/off LED
- 6.4 Set Auto-Lock Time
- 6.5 Set Language
- 6.6 Set IR Lights
- 6.7 Set Positioning
- 6.8 Set Satellite Time Synchronization
- 6.9 Set Quick Charging Mode
- 6.10 Set Overwriting
- 6.11 Set Password Verification
- 6.12 View Battery Information
- 6.13 View System Information
- Chapter 7 Body Camera Assistant
- Chapter 8 Troubleshooting
Body Camera User Manual
11
When the body camera is being charged, LED 1 is solid red. When it is fully charged, LED 1 is
solid green.
You can enable quick charging mode in system settings. In quick charging mode, the body
camera cannot be operated. If quick charging mode is disabled, you can operate the body
camera normally when the body camera is being charged. Refer to Chapter 6.9 Set Quick
Charging Mode for details.
1.4.3 How to Protect Charger
Once charging completed, disconnect the connection between charger and body camera, and
the connection between charger and power supply.
Handle with care. In case the charger or USB data cable is physically damaged or is affected
with damp, do not keep using it. You can contact us to change charger.
To protect device and your security, do not touch the body camera, charger, and USB cable
with wet hand.
Do not pull out charger from power supply by pulling the USB data cable.