User Manual

Figure 4-3 Add the Radar to the Map
2. Adjust the radar posion. Drag the radar to change the posion, and rotate and drag on
the arc side of the fan to rotate the direcon of the radar detecon area.
Note
• You can click the
direcon buons in the upper le corner on the map or drag the yellow
slider in the lower right corner on the map to adjust the range of displayed map, and slide the
block on the zoom in/out bar on the zoom control strip on the le side of the map to adjust
the size of displayed map.
• Right click on the radar area (gray sector), you can click Delete to delete the radar area, and
click Arm or Disarm to start/stop the arming mode.
3. Right click in the radar area, select pin to x the radar area. Try to ensure that the posion and
direcon of the radar on the map are consistent with the actual installaon posion and
direcon of the radar.
4. Oponal: Right click on the radar area (the fan area) to open the radar sengs menu.
Menu
Descripon
Delete Delete the radar from the map.
Arm Open the arming mode of the radar detecon area.
Note
If there is a target in the warning zone when arming, a prompt will appear:
There are targets in the zone, enable mandatory arming?, and click OK to arm.
Disarm Close the arming mode of the radar dectcon area.
Pin Fix the radar on the map.
Security Radar User Manual
8