User Manual

Chapter 5 Camera Linkage Sengs
The radar can work with cameras such as speed dome and box camera for target tracking and
video recording.
5.1 Set Speed Dome Inial Posion
Set the inial posion of the speed dome to ensure the tracking accuracy.
Steps
1. Select a reference object about 50 m away from the speed dome. On the reference object,
select a reference point whose
altude is the same as the speed dome's.
2. Enter the IP address of the speed dome in the web browser to enter the web client. Adjust the
PTZ buons to make sure that the reference point is displayed in the live view window. Click
to enable 3D locaon, click the reference point and the point will be in the middle of the frame.
Figure 5-1 Reference Point Posion
Note
• If the speed dome is installed
lted, aer you click , you may nd the reference point is
above the center of the frame or it is outside the frame. In this case, you should adjust the
maximum elevaon angle of the speed dome. For detail adjustment method, please refer to
How to Solve the Problem that No Reference Point is on the Frame While Seng the Speed
Dome Inial Posion?
• if the maximum
elevaon angle of the speed dome is adjusted, the reference point needs to
be adjusted to the center of the frame again.
• PTZ: Pan
/lt /zoom.
3. Enter the Conguraon → PTZ → Inial Posion page, and click Set to set the inial posion.
Security Radar User Manual
15