User Manual

Figure 5-3 Add a Camera
3) Click OK.
3. Link zones and trigger lines to the camera.
1) Select a camera in the camera list.
2) Select zones and trigger lines in the Linkage
Sengs.
3) Click Save.
Note
Up to 4 linked cameras can be enabled simultaneously on a single radar.
4. Add the camera to the client soware.
1) In the client soware, click Control Panel → Device Management .
2) Click Add in the device list, enter nickname, IP address, port, user name, password of the
camera. Check Export to Group.
3) Click Add.
5.3 Link the Camera to the Zone
Before You Start
• Add the zone to the radar.
• Add the camera to the client soware.
Steps
1. In the client
soware, click Control Panel → Event Management → Zone Event to enter the
page/
2. Select a zone in the le list.
Security Radar User Manual
17