User Manual
Table Of Contents
- Legal Information
- Symbol Conventions
- Chapter 1 Access to Client Software/Web Client
- Chapter 2 Activation
- Chapter 3 Wired Network Settings
- Chapter 4 Radar Settings
- Chapter 5 Camera Linkage Settings
- Chapter 6 Set Record and Storage Settings
- Chapter 7 Alarm Settings
- Chapter 8 Set Radar Advanced Function
- Chapter 9 View Alarm Information
- Chapter 10 System Management
- Appendix A. Radar Mounting Height Recommendation
- Appendix B. Formatting Description
- Appendix C. Indicator Description
- Appendix D. FAQ
- D.1 How to Achieve an Optimum Detection Range?
- D.2 How to Solve the Problem that the Radar is not Shown in the Device List on the Radar Page?
- D.3 How to Adjust the Sensitivity to Avoid False Alarm?
- D.4 How to Raise the Precision of Camera Tracking?
- D.5 How to Solve the Problem that No Reference Point is on the Frame While Setting the Speed Dome Initial Position?
- D.6 What is the Reason that Failed to Draw a Zone Automatically?
- D.7 What Makes a Failed Arming?
- D.8 Why Is It Required to Remove Reflective Objects from the Radar Area?
- D.9 Why Is the Camera Unable to Track the Target?
- D.10 Common Mistakes of Calibrating Camera
Figure 7-2 Nocaon Push
2. Enable the target nocaon.
Alarm Event Nocaon
The device will push nocaons when the zone alarm is triggered or restored.
System Status Nocaon
The device will push nocaons when any status in the system is changed.
Operaon Event Nocaon
The device will push nocaons when the user operate the device.
3. Click Save.
7.3 Set Zone
Steps
1. Select the radar and click Remote
Conguraon in the client soware, or enter the radar IP
address in the address bar of the web browser. Click Alarm Module Parameters → Zone to
enter the page.
Figure 7-3 Set Zone
2. Select a zone, and click to edit the zone name and zone type.
3. Click OK to complete.
Security Radar User Manual
35