User Manual
Table Of Contents
- Legal Information
- Symbol Conventions
- Chapter 1 Access to Client Software/Web Client
- Chapter 2 Activation
- Chapter 3 Wired Network Settings
- Chapter 4 Radar Settings
- Chapter 5 Camera Linkage Settings
- Chapter 6 Set Record and Storage Settings
- Chapter 7 Alarm Settings
- Chapter 8 Set Radar Advanced Function
- Chapter 9 View Alarm Information
- Chapter 10 System Management
- Appendix A. Radar Mounting Height Recommendation
- Appendix B. Formatting Description
- Appendix C. Indicator Description
- Appendix D. FAQ
- D.1 How to Achieve an Optimum Detection Range?
- D.2 How to Solve the Problem that the Radar is not Shown in the Device List on the Radar Page?
- D.3 How to Adjust the Sensitivity to Avoid False Alarm?
- D.4 How to Raise the Precision of Camera Tracking?
- D.5 How to Solve the Problem that No Reference Point is on the Frame While Setting the Speed Dome Initial Position?
- D.6 What is the Reason that Failed to Draw a Zone Automatically?
- D.7 What Makes a Failed Arming?
- D.8 Why Is It Required to Remove Reflective Objects from the Radar Area?
- D.9 Why Is the Camera Unable to Track the Target?
- D.10 Common Mistakes of Calibrating Camera
Appendix B. Formang Descripon
You can restore all parameters to default sengs for formang the security radar by the reset
buon.
You can format the device as follows.
Steps
1. Power
o the radar, and then hold the reset buon while powering the radar on.
2. Keep holding unl the red and green LED ashes for 6 mes, then release the reset buon and
the radar will restart again.
3. All parameters will be restored to default values
aer the radar restarts, and you need to
reacvate the radar.
Security Radar User Manual
47