User Manual

Appendix D. FAQ
D.1 How to Achieve an Opmum Detecon Range?
Answer:
You can refer to Radar Mounng Height Recommendaon for installaon of radar, and you should
test the radar aer installaon to make sure it is properly mounted. The test method is as follows:
Note
You need to enable OSD funcon before tesng.
The near detecon distance: arrange a tester to move directly from 20 m in front of the radar unl
the tester track disappear on the radar detecon area. The last tester distance that displayed by
OSD, is the near detecon distance.
The far detecon distance: Arrange a tester to move from the directly ahead of the radar and far
away from the radar
installaon posion (outside the radar detecon area) to the radar detecon
area. When the target track rst appears in the detecon area, the tester stops moving. The last
tester distance that displayed by OSD, is the far detecon distance.
Note
When tesng the far detecon distance, the tester is required to move along the center normal of
the detecon area, to ensure opmum far detecon distance.
According to the tested near detecon distance and far detecon distance, and refer to Table A-1
Radar Mounng Height and Detecon Range to adjust the radar mounng angle.
D.2 How to Solve the Problem that the Radar is not Shown in the Device
List on the Radar Page?
Answer:
You should delete the radar and add it to the client
soware again.
Note
The port number of the radar should be 80. When you add the radar to the client soware, set the
Port as 80.
D.3 How to Adjust the Sensivity to Avoid False Alarm?
Answer:
Security Radar User Manual
49