User Manual

• If there are shrubs in the radar
led, set the radar sensivity mode as Shrub Mode, which helps
avoid the false alarm caused by gale, storm, or shrub swing.
• If Shrub Mode is not saed, set the sensivity mode as Expert Mode (Custom Mode). Set the
Signal Sensivity less than or equal to two, the Swing Sensivity less than ve, and the Tracking
Sensivity less than or equal to ve.
D.4 How to Raise the Precision of Camera Tracking?
Answer:
• Check if the speed dome inial posion is set, if not, please set the speed dome inial posion.
• Check if the calibraon points are correct. Pay aenon to the situaon that the target is
intercepted when calibrang. If the calibraon points are error, please calibrate again.
• Check if the calibraon posions is equally distributed when you set the mul-point calibraon.
• Do not move the speed dome manually aer the calibraon. If the speed dome is manually
moved, please reset the inial posion of the speed dome and then calibrate again.
D.5 How to Solve the Problem that No Reference Point is on the Frame
While
Seng the Speed Dome Inial Posion?
Answer:
If the speed dome is
lted, it may cause that the reference point is above the center of the frame
or outside the frame while seng the speed dome inial posion. In this case, you should adjust
the maximum
elevaon angle of the speed dome as follows.
Steps
1. Enter the IP address of the speed dome in the web browser to enter the web client.
2. Click to expand the PTZ list on the Live View page, and then click to enter the main menu of
the speed dome.
Figure D-1 The Main Menu of Speed Dome
Security Radar User Manual
50