User Manual
Table Of Contents
- Legal Information
- Symbol Conventions
- Chapter 1 Access to Client Software/Web Client
- Chapter 2 Activation
- Chapter 3 Wired Network Settings
- Chapter 4 Radar Settings
- Chapter 5 Camera Linkage Settings
- Chapter 6 Set Record and Storage Settings
- Chapter 7 Alarm Settings
- Chapter 8 Set Radar Advanced Function
- Chapter 9 View Alarm Information
- Chapter 10 System Management
- Appendix A. Radar Mounting Height Recommendation
- Appendix B. Formatting Description
- Appendix C. Indicator Description
- Appendix D. FAQ
- D.1 How to Achieve an Optimum Detection Range?
- D.2 How to Solve the Problem that the Radar is not Shown in the Device List on the Radar Page?
- D.3 How to Adjust the Sensitivity to Avoid False Alarm?
- D.4 How to Raise the Precision of Camera Tracking?
- D.5 How to Solve the Problem that No Reference Point is on the Frame While Setting the Speed Dome Initial Position?
- D.6 What is the Reason that Failed to Draw a Zone Automatically?
- D.7 What Makes a Failed Arming?
- D.8 Why Is It Required to Remove Reflective Objects from the Radar Area?
- D.9 Why Is the Camera Unable to Track the Target?
- D.10 Common Mistakes of Calibrating Camera
Chapter 2 Acvaon
In order to protect personal security and privacy and improve the network security level, you
should
acvate the device the rst me you connect the device to a network.
2.1 Acvate Device via Client Soware
Before You Start
• Get the iVMS-4200 client soware from the supplied disk or the ocial website hp://
www.hikvision.com/en/ . Install the soware by following the prompts.
• The device and the PC that runs the
soware should be in the same subnet.
Steps
1. Run the client soware.
2. Enter Device Management or Online Device.
3. Check the device status from the device list, and select an inacve device.
4. Click
Acvate.
5. Create and conrm the admin password of the device.
Cauon
STRONG PASSWORD RECOMMENDED-We highly recommend you create a strong password of
your own choosing (using a minimum of 8 characters, including upper case leers, lower case
leers, numbers, and special characters) in order to increase the security of your product. And
we recommend you reset your password regularly, especially in the high security system,
reseng the password monthly or weekly can beer protect your product.
6.
Click OK to start acvaon.
Device status will change to Acve aer successful acvaon.
7. Edit IP address of the device.
1) Select a device and click Modify Nenfo at Online Device.
2) Change the device IP address to the same subnet with your computer by either modifying
the IP address manually or checking DHCP.
3) Input the admin password of the device and click OK to complete
modicaon.
2.2
Acvate via SADP
SADP is a tool to detect, acvate and modify the IP address of the device over the LAN.
Security Radar User Manual
2