User Manual

Specificaon
8
5
7
Operaon Cauon and Device Maintenance
- All the electronic operaon should be strictly compliance with the electrical safety regulaons, fire prevenon regula-
ons and other related regulaons in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon. Avoid
the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then please
contact the service center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon. Avoid
the equipment installaon on vibraons surface or places subject to shock (ignorance can cause equipment damage).
- Do not place the device in extremely hot (refer to the specificaon of the device for the detailed operaon tempera-
ture), cold, dusty or damp locaons, and do not expose it to high electromagnec radiaon.
Exposing the equipment to direct sun light, low venlaon or heat source such as heater or radiator is forbidden (igno-
rance can cause fire danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a
malfuncon however), and affecng the endurance of sensor at the same me.
- Improper use or replacement of the baery may result in hazard of explosion. Replace with the same or equivalent type
only. Dispose of used baeries according to the instrucons provided by the baery manufacturer.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situaon.
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
Frequency 868 MHz
Metod Two-way communicaon
Distance
1,6 KM
Indicator Red/Green
Strobe light Red/Blue (whiteon the board)
Power Baery (default power supply method) or 12 VDC
Consumpon
Quiescent Current: 40uA
Baery: Max. 3 V/4A (alerts in volume level 3 )
12 VDC: Max. 12 V/1.3A (alerts in volume level 3 )
Low Baery Cut Off
2.45 V
Voltage Range
Fully charged (new) to 2.45V DC (baery)
Baery life span
4 CR123A, 3 years in work status(triggered every two weeks and
alerng 90 s for each triggering)
Power switch Power switch
Tamper switch Front and rear tamper-proof
Piezo Decibel 102 db
Max. Sound Duraon 15min (900s)
Operaon Temperature -25 °C to 60 °C (-13 °F to 140 °F)
Operaon Humidity 10% to 90%
Material PC+ABS
Dimension (W × H × D)
190× 200 × 47. 3mm .(7.48" ×7.87" × 1.86"）
Weight 606.5g
Protecon Level IP65
Installaon Wall mounng
Power
General
RF
Indicaon
Interface
Buzzer