Quick Start Guide

Safety Instruction
These instructions are intended to ensure that user can use the product correctly to avoid danger
or property loss.
The precaution measure is divided into “Warnings” and “Cautions”.
Warnings: Serious injury or death may occur if any of the warnings are neglected.
Cautions: Injury or equipment damage may occur if any of the cautions are neglected.
Warnings
 In the use of the device, you must be in strict compliance with the electrical safety regulations of
the nation and region.
 Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power
Source with 12 VDC according to the IEC60950-1 standard. Refer to technical specifications for
detailed information.
 The output current of the power adapter must be no more than 6A.
 Do not connect multiple devices to one power adapter to avoid over-heating or a fire hazard
caused by overload.
 Make sure that the plug is firmly connected to the power socket.
 Make sure that the device is firmly fixed if wall mounting or ceiling mounting is adopted.
 If smoke, odor or noise rise from the device, turn off the power at once and unplug the power
cord, and then contact the service center.
 Never attempt to disassemble the camera by unprofessional personal.
Cautions
 Do not drop the camera or subject it to physical shock.
 Do not place the camera in extremely hot, cold (the operating temperature shall be -40° to 60° C),
dusty or damp locations, and do not expose it to high electromagnetic radiation.
 Do not touch senor modules with fingers.
 If cleaning is necessary, use clean cloth with a bit of ethanol and wipe it gently.
 Do not aim the camera at the sun or extra bright places.
 The sensor may be burned out by a laser beam, so when any laser equipment is in using, make
sure that the surface of sensor will not be exposed to the laser beam.
 Do not expose the device to high electromagnetic radiation or extremely hot, cold, dusty or
damp environment.
 To avoid heat accumulation, good ventilation is required for the operating environment.
 Keep the camera away from liquid while in use for non-water-proof device.
 While in delivery, the camera shall be packed in its original packing, or packing of the same
texture.
Mark Description
Mark Description
DC Voltage
Warnings
Follow
these safeguards to
prevent serious injury
or death.
Cautions
Follow these
precautions to prevent
potential injury or
material damage.