Quick Start Guide

ECI-B64Z2 Quick Start Guide
QSG ECI-B64Z2 041018NA 5
Zoom and Focus Adjustment via Web Browser Figure 2-9
2.4 Installation of Network Cable Water-Resistant Jacket (Optional)
Purpose:
If the camera is installed outdoors, you can connect a water-resistant accessory to the
network cable to protect it from water accumulation.
① ② ③ ④
⑤
⑥ ⑦
Figure 2-10 Waterproof Accessory Components
Table 2-1 Components
No. Components
1 Network Interface Socket
2 O-Type Gasket
3 Network Plug
4 Water-Resistant Endcap
5 Water-Resistant Rubber Gasket
6 Lock Nut
7 Network Cable from Router/Switch
Steps:
1. Feed the plugless network cable ⑦ through the lock nut ⑥, water-resistant rubber
gasket ⑤ (the rubber gasket inset ridge must face the water-resistant endcap), and the
water-resistant endcap ④.
2. Crimp an RJ-45 network plug ③ onto the end of the cable, making sure to insert the
twisted pairs of wires in the correct order.
3. Place the O-type gasket ② onto the end of the camera’s network interface socket ①.
4. Insert the network plug ③ into the camera’s network interface socket ①.
5. Insert the water-resistant rubber gasket ⑤ into the water-resistant endcap ④, and
secure the lock nut ⑥ with the water-resistant endcap ④.