Quick Start Guide

D12Fx Network Dome Camera Quick Start Guide
QSG VE D12Fx 030218NA 11
Activation via SADP Software 3.2.2
SADP software is used for detecting online devices, activating cameras, and resetting
passwords.
SADP can be obtained from the supplied disk or the official website, and installed by
following the prompts.
Follow the steps to activate the camera.
Steps:
1. Run the SADP software to search the online devices.
2. Check the device status from the device list, and select the inactive device.
Select inactive device.
Input and confirm
password.
SADP Interface Figure 3-4
Note:
SADP supports batch camera activations. Refer to the SADP user manual for further
details.
3. Create, input, and confirm a password.
STRONG PASSWORD RECOMMENDED – We highly recommend creating a strong
password of your own choosing (using a minimum of eight characters, including
upper case letters, lower case letters, numbers, and special characters) in order to
increase the security of your product. We also recommend regularly resetting your
password on a weekly or monthly basis, especially in high security systems.
Note:
You can enable the Hik-Connect service for the device during activation. Refer to Chapter
5.1 for detailed information.
4. Click Activate to start activation.
You can check whether activation is complete in the pop-up window. If activation fails,
make sure that the password meets the requirements, and try again.