Quick Start Guide

D12Fx Network Dome Camera Quick Start Guide
QSG VE D12Fx 030218NA 14
6. Reopen the Web browser after plug-in installation and repeat steps 2 to 4 in order to log
in.
Note:
For further configuration instructions, refer to the network camera user manual.
5 Hik-Connect
Purpose:
Hik-Connect is a mobile application to view live camera images, receive alarm notifications,
etc.
Enable Hik-Connect for Use with Cameras 5.1
Purpose:
Enable Hik-Connect should on your camera before using the service.
You can enable the service either via SADP software or a Web browser.
Enable Hik-Connect Service via SADP Software 5.2
Steps:
1. Check the Enable Hik-Connect checkbox:
1). For the “Activate the Device” page that appears during camera activation, refer to
Chapter 3.2.2.
2). For the “Modify Network Parameters” page that appears while modifying the IP
address, refer to Chapter 3.3.
2. Create or change the verification code.
Verification Code Setting (SADP) Figure 5-1
Note:
The verification code is required when adding the camera to Hik-Connect.