Quick Start Guide

QSG VE ECI-D62Z2 030218NA 18
Platform Access Configuration (Web) Figure 5-2
3. Set the Platform Access Mode to Hik-Connect.
4. Check the Enable checkbox.
5. Click and read the “Terms of Service” and “Privacy Policy” in the pop-up window.
6. Create or change the verification code for the camera.
Note:
A verification code is required when you add the camera to Hik-Connect.
7. Save the settings.
Add Camera to Hik-Connect 5.3
Before You Start:
You need to enable Hik-Connect on the camera before adding it to your Hik-Connect
account. Refer to Chapter 5.1.
Steps:
1. Use a network cable to connect the camera to a router if the camera does not support
Wi-Fi.
Figure 5-3 Connect a Router
Note:
After the camera connects to the network, wait one minute before using the camera with
Hik-Connect.
2. Add the camera to the Hik-Connect app:
• If Accessing the Camera through an NVR: Tap “+” on the upper-right corner and scan
the QR code that appears in the NVR interface.
• If Accessing the Camera through a Web Browser: Tap the icon and type in the
camera’s serial number.
3. Input your camera’s verification code.
Note:
The required verification code is created or changed when you enable Hik-Connect on
your camera.
Forgotten verification codes can be recovered in the Platform Access configuration page
via the web browser.
4. Follow prompts to set up the network connection and add the camera to your
Hik-Connect account.