EPI-4215-DE3-Quick-start-Guide

QSG EPI-4215-DE3 030518NA v
 If smoke, odor or noise rise from the device, turn off the power at once and unplug
the power cable, and then contact the service center.
 If the product does not work properly, contact your dealer or the nearest service
center. Never attempt to disassemble the speed dome yourself. (We shall not assume
any responsibility for problems caused by unauthorized repair or maintenance.)
Cautions
 If the speed dome fails to synchronize local time with that of the network, you need
to set up speed dome time manually. Visit the speed dome (via web browser or client
software) and enter system settings interface for time settings.
 Make sure the power supply voltage is correct before using the speed dome.
 Do not drop the speed dome or subject it to physical shock, and do not expose it to
high electromagnetism radiation. Avoid installation on vibrations surface or places
subject to shock (ignorance can cause device damage).
 Do not touch senor modules with fingers. If cleaning is necessary, use clean cloth with
a bit of ethanol and wipe it gently. If the speed dome will not be used for an extended
period, replace the lens cap to protect the sensor from dirt.
 Do not aim the speed dome at the sun or extra bright places. Blooming or smearing
may occur otherwise (which is not a malfunction), and affect the endurance of sensor
at the same time.
 The sensor may be burned out by a laser beam, so when any laser equipment is in
using, make sure that the surface of sensor will not be exposed to the laser beam.
 Do not place the speed dome in extremely hot, cold, dusty or damp locations, and do
not expose it to high electromagnetic radiation.
 To avoid heat accumulation, good ventilation is required for operating environment.
 Keep the speed dome away from liquid while in use.
 While in delivery, the speed dome shall be packed in its original packing, or packing of
the same texture.
 Improper use or replacement of the battery may result in hazard of explosion. Replace
with the same or equivalent type only. Dispose of used batteries according to the
instructions provided by the battery manufacturer.