User Manual

ERI-Q10x-Px NVR User Manual
UM ERI-Q10x-Px 030118NA 110
Select NAT to enter the port mapping interface. 2.
Leave the Enable UPnP checkbox unchecked. 3.
Click to activate the External Port Settings dialog box. Configure the external port no. for server 4.
port, http port, RTSP port, and https port respectively.
The value of the RTSP port no. should be 554 or between 1024 and 65535, while the value of the
other ports should be between 1 and 65535, and the values must differ from each other. If multiple
devices are configured for the UPnP™ settings under the same router, the value of the port no. for
each device should be unique.
External Port Settings Dialog Box Figure 9-18
Click OK to save the setting for the current port and return to the upper-level menu. 5.
Click Apply to save the settings. 6.
Enter the virtual server setting page of the router; fill in the blank of the Internal Source Port with the 7.
internal port value, the blank of the External Source Port with the external port value, and other
required contents.
Each item should correspond with the device port, including server port, http port, RTSP port, and
https port.
Setting Virtual Server Item Figure 9-19
The above virtual server setting interface is for reference only and may be different due to different
router manufacturers. Contact the router manufacturer if you have any problems setting a virtual
server.