User Manual

ERI-Q10x-Px NVR User Manual
UM ERI-Q10x-Px 030118NA 99
Chapter 9 Network Settings
Configuring General Settings 9.1
Purpose:
Network settings must be properly configured before you operate the NVR over a network.
Go to M
enu > Configuration > Network > General. 1.
Network Settings Figure 9-1
Configure the following settings: Working Mode, NIC Type, IPv4 Address, IPv4 Gateway, MTU, and DNS 2.
Server.
If the DHCP server is available, you can click the DHCP checkbox to automatically obtain an IP address and 3.
other network settings from that server.
The internal NIC IPv4 address should be configured for the cameras connecting to the PoE or built-in
switch network interface of the NVR.
The valid value range of MTU is 500 to 9676.
Click Apply. 4.
Configuring Advanced Settings 9.2
Configuring Hik-Connect 9.2.1
Purpose
Hik-Connect enables the mobile phone app and the service platform page (www.hik-connect.com) to access
and manage your connected NVR, providing convenient remote access to the surveillance system.