User Manual

ERI-Q10x-Px NVR User Manual
UM ERI-Q10x-Px 030118NA 3
Mandatory Electrical Requirements
Hikvision requires the following conditions and equipment for all of its electronic equipment:
• Grounding
Ensure good conductivity for all ground paths; examine ground path contact surfaces for defects, dirt,
corrosion, or non-conductive coatings that may impede conductivity. Repair or clean contact surfaces as
necessary to assure good metal-to-metal contact. Ensure fasteners are properly installed and tightened.
• Electrical Wiring
Ensure your outlets are properly wired. They can be checked with an electrical outlet tester.
• Surge Suppressor (Required)
Hikvision is not responsible for any damage to equipment caused by power spikes in the electrical power
grid. Use of a surge suppressor meeting the following specifications is mandatory for all Hikvision
electronic equipment:
• Specifications
˗ Listed by Underwriter’s Laboratories, meeting the UL 1449 Voltage Protection Rating (VPR)
˗ Minimum protection of 1,000 joules or higher
˗ Clamping voltage of 400 V or less
˗ Response time of 1 nanosecond or less
• Usage
˗ Surge suppressors must not be daisy chained with power strips or other surge suppressors
• Maintenance
˗ Replace after a serious electrical event (e.g., lighting blew out a transformer down the street)
˗ Replace yearly in storm-prone areas
˗ Replace every two years as routine maintenance
M
andatory Electrical Requirements
Hikvision requires the following conditions and equipment for all of its electronic equipment:
• Grounding
Ensure good conductivity for all ground paths; examine ground path contact surfaces for defects, dirt,
corrosion, or non-conductive coatings that may impede conductivity. Repair or clean contact surfaces as
necessary to assure good metal-to-metal contact. Ensure fasteners are properly installed and tightened.
• Electrical Wiring
Ensure your outlets are properly wired. They can be checked with an electrical outlet tester.
• Surge Suppressor (Required)
Hikvision is not responsible for any damage to equipment caused by power spikes in the electrical power
grid. Use of a surge suppressor meeting the following specifications is mandatory for all Hikvision
electronic equipment:
• Specifications
˗ Listed by Underwriter's Laboratories, meeting the U
L 1449 Voltage Protection Rating (VPR)
˗ Minimum protection of 1,000 joules or higher
˗ Clamping voltage of 400 V or less