User Manual

ERI-Q10x-Px NVR User Manual
UM ERI-Q10x-Px 030118NA 91
Set Arming Schedule of Video Tampering Figure 8-12
Select Linkage Action to set up alarm response actions of video tampering alarm (refer to Chapter 8.8 4.
Setting Alarm Response Actions).
Click OK to complete the video tampering settings of the channel. 5.
Line Crossing Detection Alarm 8.5
Purpose:
This function can be used to detect people, vehicles, and objects that cross a set virtual line. The line crossing
direction can be set as bidirectional, from left to right, or from right to left. You can set the duration for the
alarm response actions such as full screen monitoring, audible warning, etc.
Go to M
enu > Camera > VCA. 1.
Select the camera to configure the VCA. 2.
Set the VCA detection type to Line Crossing Detection. 3.
Check Enable to enable this function. 4.
Click to configure the trigger channel, arming schedule, and linkage actions for the line crossing 5.
detection alarm.
Click the Rule Settings button to set the line crossing detection rules. 6.
• Select the direction to A<->B, A->B or A<-B.
• A<->B: Only the arrow on the B side shows; when an object crosses the configured line in either
direction will be detected and alarms triggered.
• A->B:
Only an object crossing the configured line from the A side to the B side can be detected.
• B->A: Only an object crossing the configured line from the B side to the A side can be detected.
• Click-and-drag the slider to set the detection sensitivity.