User Manual

Network Camera User Manual
88
information. You can set the background picture quality and resolution. If the background image
need to be uploaded to surveillance center, check Background Upload.
People Counting Overlay
Select flow overlay type.
Select the daily reset time. Click Manual Reset if you want to reset right now.
Camera
You can set Device No. and Camera Info. for the camera, which can be overlaid on captured
picture.
Text Overlay
You can check desired items and adjust their order to display on captured pictures by .
The content of Device No. and Camera Info should be on the same page.
10.1.3 Face Capture Algorithms Parameters
It is used to set and optimize the parameters of the algorithm library for face capture.
Go to Configuration → Face Capture → Advanced Configuration → Parameters.
Face Capture Version
It lists the version of the algorithms library.
Detection Parameters
Generation Speed
The speed to identify a target. The higher the value, the faster the target will be recognized.
Setting the value quite low, and if there was a face in the configured area from the start, this
face will not be captured. It can reduce the misinformation of the faces in the wall painting or
posters. The default value of 3 is recommended.
Sensitivity
The sensitivity to identify a target. The higher the value is, the easier a face will be recognized,
and the higher possibility of misinformation would be. The default value of 3 is recommended.
Capture Parameters
Best Shot
The best shot after target leave the detection area.
Capture Times
It refers to the capture times a face will be captured during its stay in the configured area. The
default value is 1.
Capture Interval
The frame interval to capture a picture. If you set the value as 1, which is the default value, it
means the camera captures the face in every frame.