User Manual

Network Camera User Manual
90
2. Click to draw shield area. Repeat this step above to set more shield regions.
3. Optional: Click to delete the drawn areas.
4. Click Save.
10.2 Road Traffic
Motor vehicle, non-motor vehicle, and pedestrian can be detected and captured when they enter
the set lane to realize rapid detection and comprehensive surveillance of the targets on road.
Note
Only certain device models support this function.
10.2.1 Set Vehicle Detection
The vehicle that enters the set lane can be detected and the picture of the vehicle and its license
plate can be captured and stored. Alarm will be triggered and capture can be uploaded.
Before You Start
Go to Configuration → System → System Settings → VCA Resources, and select Road Traffic.
Steps
1. Go to Configuration → Road Traffic → Detection Configuration, and select Vehicle Detection as
detection type.
2. Check Enable.
3. Select the lane number.
4. Click and drag the lane line to set its position, or click and drag the line end to adjust the length
and angle of the line.
5. Adjust the zoom ratio of the camera so that the size of the vehicle in the image is close to that
of the red frame. Only the position of red frame is adjustable.
Note
Only 1 license plate can be captured at one time for each lane.
6. Select Region and Country/Region.
7. Select the license plate information upload mode.
Entrance/Exit
The license plate information of the detected vehicle will be uploaded
when the vehicle passes the detection area and triggers the detection
in entrance/exit.
City Street
The license plate information of the detected vehicle will be uploaded
when the vehicle passes the detection area and triggers the detection
in city streets.