User Manual

Network Camera User Manual
91
Alarm Input
It means the input alarm will trigger a license plate capture and
recognition action.
Note
When Alarm Input is selected, the alarm input A<-1 will automatically be assigned to trigger
vehicle detection and its alarm type is always NO.If the A<-1 alarm input is used to trigger vehicle
detection, it can not be used for other basic events.When Alarm Input is selected and saved,
previously configured linkage method for A<-1 will be canceled.
8. Select the Detection mode.
9. Check Remove Duplicated License Plates ans set the Time Interval. The default time interval is
4 minutes.
Note
Up to 8 license plates are supported.
10. Set arming schedule and linkage method. For the arming schedule settings, refer to Set Arming
Schedule. For the linkage method settings, refer to Linkage Method Settings.
11. Click Save.
10.2.2 Set Mixed-Traffic Detection Rule
The motor vehicle, non-motor vehicle, and pedestrian that enter the set lane can be detected, and
the picture of targets can be captured and stored. Alarm will be triggered and capture can be
uploaded.
Before You Start
Go to Configuration → System → System Settings → VCA Resources, ad select Road Traffic.
Steps
1. Go to Configuration → Road Traffic → Detection Configuration, and select Mixed-traffic
Detection as detection type.
2. Check Enable.
3. Select the lane number.
4. Select Region and Country/Region.
5. Set arming schedule and linkage method. For the arming schedule settings, refer to Set Arming
Schedule. For the linkage method settings, refer to Linkage Method Settings.
6. Click Save.
10.2.3 Uploading Pictures Settings
You can set the image parameters of the captured images in vehicle detection and mixed-traffic