User Manual

Network Camera User Manual
100
Steps
1. Go to Configuration → Queue Management.
2. Select Waiting Time Detection.
3. Click Add Region to draw the detection area and set Region Name and Alarm Interval. Repeat
this step above to set more areas.
Alarm Interval
During the set alarm interval, alarms of the same type only trigger one notification
Figure 10-3 Set Waiting Time Detection
4. Set Alarm threshold. An alarm is triggered when the alarm threshold condition is met.
5. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings,
refer to Linkage Method Settings.
6. Click Save.
7. Optional: Enable Display POS Information and Rule in Configuration → Local.
The detection area and the time people staying in the detection area can be viewed on the live
view.
10.5.3 Queue Management Statistics
Queue management supports data analysis and report output.
Before You Start
For queue management settings, refer to Set Regional People Queuing-Up and Set Waiting Time
Detection.
● Select Queuing-Up Time Analysis and Regional Comparison to compare queuing-up people
number of different regions.
● Select Queuing-Up Time Analysis and Multi-Level Comparison to compare queuing-up people
number of different waiting time levels.
● Select Queue Status Analysis and Regional Comparison to compare the time and duration that
a queue stays at a certain length in different regions.
● Select Queue Status Analysis and Multi-Level Comparison to compare the time and duration of