User Manual

Network Camera User Manual

6.2.5 Set Video Loss

This function can detect the video signal loss in time and trigger the linkage action.

Steps

1. Go to Configuration → Event → Basic Event → Video Loss.

2. Check Enable.

3. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for

setting linkage method.

4. Click Save.

6.2.6 Set Intrusion Detection

It is used to detect objects entering and loitering in a pre-defined virtual region. If it occurs, the

device can take linkage actions.

Steps

1. Go to Configuration → Event → Smart Event → Intrusion Detection.

2. Check Enable.

3. Select a Region. For the detection region settings, refer to Draw Area.

4. Set rules.

Sensitivity

Sensitivity stands for the percentage of the body part of an

acceptable target that enters the pre-defined region. Sensitivity = 100

- S1/ST × 100. S1 stands for the target body part that goes across the

pre-defined region. ST stands for the complete target body. The

higher the value of sensitivity is, the more easily the alarm can be

triggered.

Threshold

Threshold stands for the threshold for the time of the object loitering

in the region. If the time that one object stays exceeds the threshold,

the alarm is triggered. The larger the value of the threshold is, the

longer the alarm triggering time is.

Object

You can specify the object type to be detected and the device only

detects the selected type of object.