User Manual

Network Camera User Manual
45
sensitivity is, the more easily the alarm can be triggered.
Object
You can specify the object type to be detected and the device only
detects the selected type of object.
Figure 6-5 Set Rule
6. Optional: You can set the parameters of multiple areas by repeating the above steps.
7. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings,
refer to Linkage Method Settings.
8. Click Save.
6.2.8 Set Region Entrance Detection
It is used to detect objects entering a pre-defined virtual region from the outside place. If it occurs,
the device can take linkage actions.
Steps
1. Go to Configuration → Event → Smart Event → Region Entrance Detection.
2. Check Enable.
3. Select one Region. For the region settings, refer to Draw Area.
4. Select the detection target. Human and vehicle are available. If the detection target is not
selected, all the detected targets will be reported, including the human and the vehicle.