User Manual

Network Camera User Manual
46
Figure 6-6 Set Rule
5. Optional: You can set the parameters of multiple areas by repeating the above steps.
6. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings,
refer to Linkage Method Settings.
7. Click Save.
6.2.9 Set Region Exiting Detection
It is used to detect objects exiting from a pre-defined virtual region. If it occurs, the device can
take linkage actions.
Steps
1. Go to Configuration → Event → Smart Event → Region Exiting Detection
2. Check Enable.
3. Select one Region. For the detection region settings, refer to Draw Area.
4. Select the detection target. Human and vehicle are available. If the detection target is not
selected, all the detected targets will be reported, including the human and the vehicle.