User Manual

Network Camera User Manual

7.2 SNMP

You can set the SNMP network management protocol to get the alarm event and exception

messages in network transmission.

Before You Start

Before setting the SNMP, you should download the SNMP software and manage to receive the

device information via SNMP port.

Steps

1. Go to the settings page: Configuration → Network → Advanced Settings → SNMP.

2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.

Note

The SNMP version you select should be the same as that of the SNMP software.

And you also need to use the different version according to the security level required. SNMP v1

is not secure and SNMP v2 requires password for access. And SNMP v3 provides encryption and

if you use the third version, HTTPS protocol must be enabled.

3. Configure the SNMP settings.

4. Click Save.

7.3 Set SRTP

The Secure Real-time Transport Protocol (SRTP) is a Real-time Transport Protocol (RTP) internet

protocol, intended to provide encryption, message authentication and integrity, and replay attack

protection to the RTP data in both unicast and multicast applications.

Steps

1. Go to Configuration → Network → Advanced Settings → SRTP.

2. Select Server Certificate.

3. Select Encrypted Algorithm.

4. Click Save.

Note

● Only certain device models support this function.

● If the function is abnormal, check if the selected certificate is abnormal in certificate

management.