User Manual

Network Camera User Manual

Note

For stable use of Wi-Fi, it is not recommended to use DHCP.

3. Go to Wi-Fi settings page: Configuration → Network → Advanced Configuration → Wi-Fi.

4. Set Wi-Fi parameters.

1) Check Enable WPS.

2) Select PBC connection.

3) Check on the Wi-Fi router to see if there is a WPS button. If yes push the button and you can

see the indicator near the button start flashing, which means the WPS function of the router

is enabled. For detailed operation, please see the user guide of the router.

4) Push the WPS button to enable the function on the camera. If there is not a WPS button on

the camera, you can also click the virtual button to enable the PBC function on the web

interface.

5) Click Connect.

5. Click Save.

6. Set PBC code for wireless router or AP.

– Press the WPS or QSS button on the wireless router or AP in 120 second to quickly complete

the connection.

– Refer to the user guide of the router or AP to set PBC code.

7. Go to TCP/IP setting page: Configuration → Network → Basic Configuration → TCP/IP, and click

Wlan to check the IPv4 Address and log in the device.

– Input the IP address in the browser to access the device.

– Add the device in client application. Select IP/Domain, and input IP address and other

parameters to access the device.

Use PIN on Device

The device can automatically connect the network by setting the device PIN code parameters in

wireless router or AP via WPS or QSS protocols.

Steps

1. Go to TCP/IP settings page: Configuration → Network → Basic Configuration → TCP/IP.

2. Select Wlan to set the parameters. Refer to TCP/IP for detailed configuration.

Note

For stable use of Wi-Fi, it is not recommended to use DHCP.

3. Go to Wi-Fi setting page: Configuration → Network → Advanced Configuration → Wi-Fi.

4. Check Enable WPS.

5. Click Generate to generate a device PIN code.

6. Refer to the user manual of wireless router or AP to input the code to the router or AP.

7. Go to TCP/IP settings page: Configuration → Network → Basic Configuration → TCP/IP, and

click Wlan to check the IPv4 Address and log in the device.