User Manual

Network Camera User Manual

9.10.3 Synchronize Time by Satellite

Note

This function varies depending on different devices.

Steps

1. Enter Configuration → System → System Settings → Time Settings.

2. Select Satellite Time Sync..

3. Set Interval.

4. Click Save.

9.10.4 Set DST

If the region where the device is located adopts Daylight Saving Time (DST), you can set this

function.

Steps

1. Go to Configuration → System → System Settings → DST.

2. Check Enable DST.

3. Select Start Time, End Time and DST Bias.

4. Click Save.

9.11 Set RS-485

RS-485 is used to connect the device to external device. You can use RS-485 to transmit the data

between the device and the computer or terminal when the communication distance is too long.

Before You Start

Connect the device and computer or termial with RS-485 cable.

Steps

1. Go to Configuration → System → System Settings → RS-485.

2. Set the RS-485 parameters.

Note

You should keep the parameters of the device and the computer or terminal all the same.

3. Click Save.