User Manual

Network Camera User Manual

9.12 Set RS-232

RS-232 can be used to debug device or access peripheral device. RS-232 can realize

communication between the device and computer or terminal when the communication distance

is short.

Before You Start

Connect the device to computer or terminal with RS-232 cable.

Steps

1. Go to Configuration → System → System Settings → RS-232.

2. Set RS-232 parameters to match the device with computer or terminal.

3. Click Save.

9.13 External Device

For the device supporting external devices, including the supplement light, wiper on the housing

and the LED light, you can control them via the Web browser when it is used with the housing.

External devices vary with models.

Brightness

Adjust Low Beam Brightness and High Beam Brightness according to the actual scene.

Timing

The LED light will be turned on by the schedule you set. You should set Start Time and End

Time.

Auto

The LED light will be turned on according to the environment illumination.

9.13.1 Supplement Light Settings

You can set supplement light and refer to the actual device for relevant parameters.

Smart Supplement Light

Smart supplement light avoids over exposure when the supplement light is on.

Supplement Light Mode

When the device supports supplement light, you can select supplement light mode.

IR Mode

IR light is enabled.

White Light Mode

White light is enabled.

Mix Mode