User Manual

Network Camera User Manual
165
b) Set parameters for the added region.
i. Set the region name and alarm interval.
Region Name: It is displayed as OSD information.
Alarm Interval: In the set alarm interval, alarms of the same type only
trigger one notification.
ii. Set regional people queuing-up settings.
Check OSD to display the region name and its real-time queuing-up
people number.
Alarm Trigger Condition: When the people number in the region is
greater than, less than, equal to or not equal to the set threshold, an
alarm is triggered.
Alarm threshold: An alarm is triggered when the alarm threshold
condition is met.
iii. Set waiting time detection settings.
Alarm Trigger Condition: When the people number in the region is
greater than, less than, equal to or not equal to the set threshold, an
alarm is triggered.
Alarm threshold: An alarm is triggered when the alarm threshold
condition is met.
c) Repeat above steps to set up other regions if needed. Up to 3 regions are
supported.
2. Arming Schedule.
Set the arming schedule for the function. In the armed periods, the function is
active. Refer to Task 2 in 10.1.1 Configuring Motion Detection.
3. Linkage Method. Set linkage method.
For triggered alarm information, you can set the linkage action as a response to
forward the information or trigger other actions. Refer to Task 3 in 10.1.1
Configuring Motion Detection.
4. Advanced Configuration.
(Optional) Check the queue management version and set the filtering