User Manual

Table Of Contents
Network Camera User Manual
49
Steps:
1. Enter RS-232 Port Setting interface: Configuration > System > System Settings >
RS-232.
2. Configure the Baud Rate, Data Bit, Stop Bit, Parity, Flow Control, and Usage.
RS-232 Settings
Note: If you want to connect the camera by the RS-232 port, the parameters of the
RS-232 should be the same with the parameters you configured here.
3. Click Save to save the settings.
Configuring RS-485 Settings
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface: Configuration > System > System Settings >
RS-485.