User Manual

Network Traffic Camera User Manual
27
from the multicast group address. Before utilizing this function, you have to
enable the Multicast function of your router.
● Number plate data can be transmitted through ANPR protocol. Before using
this function, you have to configure ANPR IP address and ANPR port to
connect the host.
 DNS Server Configuration
DNS (Domain Name System) is a network system used to translate names into IP
address.
3. Click Save to save the settings.
8.5 Configure Port
Purpose:
Configure the HTTP port, RTSP port, SDK port information on this page.
Steps:
1. Go to Configuration > Device Configuration > System Configuration > Port.
Figure 8-5 Port Configuration
2. Configure the following parameters.
 HTTP Port: The default port number is 80, and it can be changed to any port No.
ranges from 1 to 65536 which is not occupied, except 21 (FTP port) and 23
(Telnet port).
 RTSP Port: The default port number is 554 and it can be changed to any port No.
ranges from 1 to 65536 which is not occupied, except 21 (FTP port) and 23
(Telnet port).
 SDK Port: The default server port number is 8000, and it can be changed to any
port No. ranges from 2000 to 65535 which is not occupied.
3. Click Save to save the settings.