User Manual

Network Traffic Camera User Manual
52
1) If you select Normal Mode, adjust 3D DNR Level from 0 to 100.
2) If you select Expert Mode, adjust Spatial Intensity and Time Intensity
from 0 to 100.
7. (Optional) Check 2D DNR, and adjust 2D DNR Level from 0 to 100.
8. (Optional) Check Slow Shutter and select slow shutter level.
In slow shutter mode, the shutter speed will automatically decrease in low
illumination conditions to maintain clear video images by increasing the exposure
time. Higher level means lower shutter speed.
9. Select Video Standard, 50Hz and 60Hz are selectable. Choose according to the
different video standards; normally 50 Hz for PAL standard and 60 Hz for NTSC
standard.
10. (Optional) Click Capture Test to test the effects.
12.3 Configure Picture
Purpose:
The camera supports dual-shutter. One shutter for video image and the other one for
captured image. You can configure shutter parameters for captured image.
Steps:
1. Go to Configuration > Device Configuration > Image Parameters > Picture.
Figure 12-3 Captured Image Configuration